Try OpenEdge Now
skip to main content
Servers, DataServers, Messengers, and Adapters
Managing WebSpeed Transaction Server Data : Modifying WebSpeed control settings : Agent Pool Control page content : Agent pool initial configuration
 
Agent pool initial configuration
The Agent pool initial configuration section identifies WebSpeed broker configuration properties set in the ubroker.properties file (which are also reflected in the configuration settings within OpenEdge Management). These values appear as read-only.
The following table identifies and describes each field that displays in the Agent pool initial configuration section.
Table 11. Agent pool initial configuration field definitions
Field
Description
Initial number of agents to start
The value OpenEdge Management references when the WebSpeed broker starts agents. Depending on your license agreement and your strategy for setting up your configuration information, this value may be the same as the value displayed in the Licensed agents field.
Minimum agents
The minimum number of agents that must be simultaneously running before the WebSpeed broker will start additional agents. The broker strives to maintain this specified minimum. If at any time the number of agents falls below the specified minimum, the broker will automatically start the additional agents necessary to maintain this minimum. If you set a trim value that would require OpenEdge Management to trim the number of agents below the number specified for this field, OpenEdge Management displays a message.
Maximum agents
The maximum number of WebSpeed processes that can be running simultaneously. OpenEdge Management will not fulfill add requests you initiate that exceed this specified maximum. OpenEdge Management will display a message to state this condition so that you can reconsider your request and, if necessary, initiate a new request.