To configure a basic data source to test your connection:
1. From the Progress DataDirect program group, start the ODBC Administrator.
2. Click either the User DSN, System DSN, or File DSN tab to display a list of data sources.
User DSN: If you installed a default DataDirect ODBC user data source as part of the installation, select the appropriate data source name and click Configure to display the driver Setup dialog box.
If you are configuring a new user data source, click Add to display a list of installed drivers. Select the Amazon Redshift Wire Protocol driver and click Finish to display the driver Setup dialog box.
System DSN: To configure a new system data source, click Add to display a list of installed drivers. Select the Amazon Redshift Wire Protocol driver and click Finish to display the driver Setup dialog box.
File DSN: To configure a new file data source, click Add to display a list of installed drivers. Select the Amazon Redshift Wire Protocol driver and click Advanced to specify attributes; otherwise, click Next to proceed. Specify a name for the data source and click Next. Verify the data source information; then, click Finish to display the driver Setup dialog box.
3. The General tab of the Setup dialog box appears by default.
Note: The General tab displays only fields that are required for creating a data source. The fields on all other tabs are optional.
On the General tab, provide the following information; then, click Apply.
Data Source Name: Type a string that identifies this data source configuration, such as Accounting.
Description: Type an optional long description of a data source name, such as My Accounting Database.
Host Name: Type the URL or IP address of the interface to which you want to connect.
Port Number: Type the port number of the server listener. The default is 5439.
Database Name: Type the name of the database to which you want to connect.
4. Your driver is now configured with the basic settings necessary to connect your driver. Choose from the following:
If you would like to test the connection, proceed to "Testing the Connection."
If you would like to tune your driver for performance, proceed to "Tuning for Performance."
If you would like to save the values you have specified and close the setup dialog, click OK. These values will be used as the default settings when you connect to a data source.